Ghost Wire 2.0, Super Flat Adhesive Speaker Wire, 16 AWG, 2 Conductor, 100 ft. Spool, White

Sewell Part # SW-32985-100

$97.95

4.0 (3 reviews)

In Stock


  • 1+   $97.95

  • 5+   $91.95

  • 10+   $87.95

  • 20+   $83.95

  • 30+   $77.95

  • 50+   $74.95

  • 100+   $72.95

  • 200+   $70.95

"The entire process was perfect - good price, good quality, good service, quick delivery."

Overview

Make speaker wires disappear right on the wall or under the carpet with Sewell Adhesive Speaker Wire.

This super-flat speaker wire can be used on almost any flat surface. Perfect for running stereo signals across rooms, around corners, in automobiles, under flooring, or any situation where wires cannot be run through walls.

White backing allows wires to be simply attached and left uncovered, or it can be easily covered with paint, spackle, or flooring making the wire virtually invisible.

For an even cleaner install we recommend using the Ghost Wire Terminal Block to connect the Ghost Wire to your regular speaker wire.


How to Terminate Ghost Wire

  1. Peel back the white backing about 1” and cut it off, exposing the adhesive and conductors
  2. Trim away white covering in between and at the edges of the conductors
  3. Remove the white covering from the opposite side of the conductor. It does not have adhesive between it and the conductor and should leave a nice clean copper surface when removed
  4. Fold the conductors 2-4 times, keeping the clean copper surface outwards
  5. Insert the conductors into the Terminal Block and tighten the set screws
  6. Insert your standard speaker cable in the other end of the terminal block and tighten the set screw.

How Remove Bubbles from Ghost Wire

  1. Install the ghost wire onto a clean surface, pulling it tight as you do.
  2. Use a heat gun on low or hair dryer on high to heat the area where bubbles appear
  3. Smooth out the bubbles by rubbing back and forth over them. Use a glove if the heat is uncomfortable.

Running Ghost Wire Around Corners

We’ve had a lot of people ask us how to 90° turns when running it along the floor.

Here’s how:

  1. Run the cable along the edge of the wall with the adhesive side facing down
  2. Fold the cable back so the copper strips are facing up
  3. Fold the cable back down at a 45° angle, making a 90° turn
Ghost Wire Installation

Tips and Tricks

For even more Ghost Wire tips and tricks, check out the Ghost Wire installation guide

Specifications

Mfg. Part Number

  • SW-32985-100

Brand

  • Ghost Wire™ by Sewell

Specifications

  • .75" Width (each conductor)
  • .5 mm thick (includes peel back layer, adhesive, and conductors)
  • 16 AWG
  • Pure Copper
  • 2 Conductor
  • White Jacket
  • Rated up to 10 Amps
  • Indoor/Outdoor Use

Applications

  • Home Theater Surround Sound Speaker Wiring
  • Low Voltage Stage Lighting
  • 12 Volt Cabinet Lighting
  • Security Access Control Wiring

Reviews

3 Total Reviews -

See all reviews
(1) 33.3 %
(1) 33.3 %
(1) 33.3 %
(0) 0.0 %
(0) 0.0 %

Not Rated

(0) 0.0 %

Have experience with this product?


Most helpful reviews

Adhesive needs to be better

- 6/28/2018 1:40:13 PM

1 found this review helpful


Pros: Clean install look

Cons: Adhesive is not the best on walls, edges of tape don't stick well

Other: I end up having to continually re adhere the tape as edges come undone.

Was this review helpful?

Great product

- 9/21/2018 7:28:27 AM

0 found this review helpful


Pros: Easy to install. Excellent videos for support. Looks great and works perfectly

Cons: Adhesive not quite as strong as I'd hoped

Other: It took me about 45 minutes to install for two rear speakers. The tape went up easily and with the four conductors attaching speaker wire was simple. I appreciate the clever solution for running wires. I plan on applying drywall mud and painting, but I haven't done so yet.

Was this review helpful?

Wall wired

Jimmy C - 9/21/2018 8:20:44 AM

0 found this review helpful


Pros: Easy to use.

Cons: Tends to stand out on flat surfaces. Connectors are much bulkier than required, a solderable or compression connection could be better.

Other: If the edges of the tape were "feathered", the tape would blend into flat surfaces much better.

Was this review helpful?

See all reviews

Most recent reviews

Wall wired

Jimmy C - 9/21/2018 8:20:44 AM

Easy to use.

Was this review helpful?

Great product

- 9/21/2018 7:28:27 AM

Easy to install. Excellent videos for support. Looks great and works perfectly

Was this review helpful?

Adhesive needs to be better

- 6/28/2018 1:40:13 PM

Clean install look

Was this review helpful?

Questions

Currently no questions are available

Ask us a new question about:
Ghost Wire 2.0, Super Flat Adhesive Speaker Wire, 16 AWG, 2 Conductor, 100 ft. Spool, White,