Sewell 4 Conductor Ghost Speaker Wire, 18 AWG, 50 ft.

Check Out the New Ghost Wire 2.0 with improved adhesive backing!

We recommend using the Sewell Ghost Wire Terminal Block with this product.

Make speaker wires disappear right on the wall or under the carpet with Sewell Adhesive Speaker Wire.

This super-flat speaker wire can be used on almost any flat surface. Perfect for running stereo signals across rooms, around corners, in automobiles, under flooring, or any situation where wires cannot be run through walls.

Clear backing allows wires to be simply attached and left uncovered, or it can be easily covered with paint, wall paper, or flooring making the wire virtually invisible.

Easy stick-on installation saves you from the difficult task of pulling wires through walls or attics. Simply peel back the yellow adhesive covering and stick the industrial strength self-adhesive side wherever you want it. No screwdrivers, hammers, or jigsaws required.

Installing Ghost Speaker Wire

1. Peel back the top and bottom layers of the cable exposing the bare conductors
2. Fold the conductors over 2-3 times and insert them into the Ghost Wire Terminal Block
3. Tighten the screws on the terminal block to secure the cable
4. Insert speaker cable and tighten screws

Running Ghost Wire Around Corners

We’ve had a lot of people ask us the best way to run Ghost wire around corners when running it along the floor.

Here’s how:

1. Run the cable along the edge of the wall with the adhesive side (the side with the two copper strips) down
2. Fold the cable back so the copper strips are facing up
3. Fold the cable back down at a 45° angle, making a 90° turn