| |
|
 | LTA41 |
| |
|
| FibroLAN |
| |
|
| 4:1 traffic aggregation for 75% savings • Extensive remote monitoring and Control |
| VLANs for users separation • Distances up to 150km |
| Trouble-free deployment - connects to any Single - Fiber - Strand option Bi-Di traffic network equipment |
| Extended Temperature Range option for |
| FEF and TEST mode for enhanced diagnostics outdoor deployment |
| |
|
| Standard Compliance: IEEE802.3u, 100Base-TX, 10Base-T, 100Base-FX |
| VLAN per port |
| 10/100Base-TX ports 1 4(1 3 in LTA31M): Shielded RJ-45, auto-cross, auto-polarity 100m over UTP/STP cat.5 or higher cable HDX/FDX via auto-negotiation or forced (DIP) 10Base-T auto-negotiation or forced (DIP) |
| 100Base-FX port: Duplex SC connector (ST optional) Far End Fault Signaling |
| HDX/FDX selection 1310nm multi-mode - -18dbm min. output power, -32dbm or better sensitivity Optional single-mode for 7/15/25/40/70/100/150km - see separate table Single Fiber Strand (/SMF1x) models |
| Conversion Method: BMD™ (Buffered Media Domain), Full wire speed, 1000 MAC addresses, FDX flow control, HDX back- |
| pressure flow control |
| Diagnostics: per port: FX port: Link/Activity, FDX |
| TX ports (each): Link/Activity, FDX, 100 |
| per system: Power, Link Test |
| Controls: FX port: FDX/HDX, Test TX port #4:10/100, FDX/HDX, A/N enable-disable |
| TX ports 1 3: Auto-negotiation /FDX-10 |
| Management Section: RS232 (miniDIN) terminal connector |
| LEDs: RCV, Ready |
| |
|
| Power-Supply: Internal, 100 240VAC, 50 60Hz -36 72VDC optional |
| Power Consumption: 15W max. |
| Operating Temperature: 0° 45°C, ETR = -10° +70°C optional |
| Storage Temperature: -20° +80°C Humidity 10% 90% non-condensing |
| Weight: 600gram |
| Safety: UL 1950:1955, EN 60950 |
| Dimensions: 223x44x150mm (WxHxD) |
| EMC: FCC part 15, subpart A, Class A, VCCI Class A ICES 003:1997, Class A, EMC Directive 89/336/EEC |
