| |
|
 | SP-1130 |
| |
|
| Splitronic |
| |
|
| Splitronic Broadband Aggregator |
| Power Cable |
| User Manual |
| |
|
| WAN Port: 2 x 10M/100M port |
| LAN Port: 1 x 10M/100M |
| CPU: MIPS with 150MHz |
| Memory: Flash: 2MB, SDRAM: 16MB |
| Indicator (6 LEDs): Power, Alarm, LAN 10M & 100M, WAN1 & WAN2 |
| Reset Switch: Push to load factory default value or back to latest configuration file |
| Power: 5V DC/2.8A |
| |
|
| Out-bound Load Balance: Provides 3 working modes (Session, weight round robin, dynamic traffic) |
| Protocol: TCP/IP, UDP, ARP, BOOTP, ICMP, Routing Protocol, DHCP server/client, FTP, TFTP, Telnet, PPPoE |
| VPN pass through: IPSEC, PPTP |
| Routing Protocol: Static Route, RIP 1, RIP 2 |
| Dynamic DNS: Supports dyndns.org, dtdns.com, 88ip.com, oray.net |
| Working mode: Router mode, Gateway mode, Basic NAT mode |
| Security: DMZ Host, Multi NAT/NAPT, PAP/CHAP, Virtual Server Mapping support, Internet Access Control (Packet filtering base on port & address) |
| Firewall:DoS (Denial of Service) protection, including Active ports scan, TCP SYNC flood, ICMP flood, IP source route option detection, IP spoofing, Ping of death, IP fragment overlap, UDP flooding, PING oversize, Ping Enable/Disable |
| Mail Alert: WAN up, WAN down, DoS attack, System Log |
| System Timer: NTP (Network Timer Protocol), Use PC local time |
| System Log: Local event logging |
| DHCP Server/Client: DHCP Server can reserved up to 253 IP, supports up to 512 users |
| Firmware upgrade: HTTP web based download/TFTP |
| Configuration file: Backup the configuration file into PC, Restore the saved configuration file into the device |
| Remote Configure: Configure Router through Internet |
